Multiplayer Manual

Introduction

One of the most interesting features of the Post T and Stellwerk simulation series is the ability for a player to host a multiplayer dispatching session, that is, other players on different computers are all able to dispatch simultaneously within the same simulation. Dispatching information is sent between players via a computer network, either a local area network (LAN) like you’ll find in your home and workplace, or via the Internet.

A player initiating a session is called a server operator. A player wanting to join a session uses the client computer application to connect to the server. Only the server operator needs to have purchased Post T or Stellwerk simulation – the client application (Post T MultiPlayer) is free.

Connecting to a server is usually easy; setting up a server often requires some configuration. This document aims to help you to set up a multiplayer server.

Enabling MultiPlayer

The multiplayer system within the dispatching simulation adds some computational overhead; it is disabled by default. In order to access the MultiPlayer controls from within the simulation, the multiplayer option needs to be enabled. To enable the MultiPlayer system, navigate to the Dispatcher Center in the Settings menu, and ensure that the checkbox is checked

ínsert image here

When MultiPlayer is enabled, the Dispatcher Center menu item is available during a simulation.

Things to Know and Do Before Starting

Ports

When one computer sends data to another computer via a network, the data is usually sent from, and to, specified ports. Network ports aren’t like physical ports you find at the back of your computer for connecting monitors and keyboards – network ports are “software addresses” that allow computer programs to be specific about where in the target machine the data is to be sent.

If you’re surfing the web with a browser, while simultaneously chatting using an instant messaging application, web data is sent to a different port than the data coming in from the person you’re chatting with.

Post T / Stellwerk simulation series expects data to arrive via a specific port – you can specify which port to use, but by default, port 55386 is used.

Post T / Stellwerk simulations use port 55386 by default for incoming traffic.

Port Forwarding

The router in a typical LAN acts as a gateway between computers in that LAN, and other machines outside of the LAN. Normally, requests for data from outside a LAN are rejected by the router for security purposes.

In order to instruct the router that traffic destined for Post T / Stellwerk simulation should be allowed, port forwarding must be turned on. In simple terms, the router must be told to allow traffic destined for a specific port (in this case, 55386) to be forwarded to your specific IP address.

Consult your router’s manual, or visit PortForward.Com to see if your router is listed. For convenience, sample port forwarding is shown below:

insert imgae here

The simulation strictly uses TCP for all multiplayer traffic. The computer to which data is forwarded is specified by an IP address. It is recommended that your computer’s LAN IP address be static – consult your operating system’s manual to learn how to configure your machine to use a static IP. Refer to the Section "Other Helpful Resources" for some online resources that will help you set up a static IP and port forwarding.