Fax-System
Inhalt | Gebrauchsanleitung und Tips Sp Dr S 60 | FAQ | Gebrauchsanleitung Betriebszentrale | Gebrauchsanleitung Streckenverbindung | Sprachkommunikation | Verzeichnis der Änderungen | Developers pages
An dieser Seite wird noch gearbeitet. Die Inhalte sind noch unter Vorbehalt!
The Fax window is accessible from the Manage menu. You may also access this window by clicking on the green 
rectangle in the status bar. The fax system is used to enable and disable additional traffic.
The window has four tabs: Sent, Received, Trash and Traffic Information. Fax messages that you send will appear in the Sent tab, while messages you receive will appear in the Received list. Fax messages that you no longer want can be placed in the Trash list.
Selecting a fax message listed in any of the first three tabs will be displayed in the right side of the window.
The Betriebsanweisungen tab shows which Betriebsanweisungen are currently active, and which traffic codes are inactive.
Sending a Fax
To create a new fax message, first click the New Fax button. An empty fax message will appear. A fax message consists of the following:
- Recipient
- The fax number of the intended recipient. To send to everyone instead, use the Send To All checkbox.
- Subject
- A short bit of text describing the nature of the fax message.
- Traffic Codes
- (optional) Used to enable or disable additional traffic. Refer to the article on Betriebsanweisungen.
- Message
- The full message.
When you are satisfied with your draft, press Send to begin sending the message. Each message takes a few seconds to actually send, so you will have to wait before you are able to send a subsequent fax message.
When the message is sent, it will appear in the sent list. Similarly, received and trashed messages appear in their respective lists.
You may omit dashes from the fax number, or you may include them if you so desire.
Fax numbers for each simulation are listed in the Telefonverzeichnis Linke Rheinstrecke.
Receiving a Fax
When a fax message is received, the green rectangle in the status bar will blink, and is accompanied by a "beep" sound. In the Fax Window, the newly received message will be found at the top of the Received list. Select the message to view it in its entirety. The format of a fax message is similar to what is shown below.
Trash
To put a message in the trash, right-click the message and choose Send to Trash. Only a limited number of fax messages may be placed in the trash. New messages will discard older messages in the trash, if no more room in the trash exists.
Resending a Fax
To send an existing message, right-click, and choose Resend. A new message will be created but the message contents will contain the text of the original message.
Adding/Removing Betriebsanweisungen
To include a Betriebsanweisungen in a fax message, select it from the dropdown list and press the green 
button. If you have previously enabled a traffic code and wish to disable it once more, select it from the dropdown list and press the red 
button. No other indication is included in the fax message - it is up to you to remember which codes you have activated.
Inhalt | Gebrauchsanleitung und Tips Sp Dr S 60 | FAQ | Gebrauchsanleitung Betriebszentrale | Gebrauchsanleitung Streckenverbindung | Sprachkommunikation | Verzeichnis der Änderungen | Developers pages